close
close

Video: Columbus driver stops on the highway so as not to miss the output, turns on blinker, causes a massive bunch

As a Chicago transplant, I am usually the first to drive the brakes (word game intends to go) on the jokes regarding the Bad Columbus. However, a current video considered me.

An approximately one-minute clip, which was published yesterday on the Facebook page (Odot) by Ohio Department of Transportation (Odot), shows a crash on the lanes to the south on the I-670 exchange. The crash occurred on April 30th.

In about the 15 -second brand, a red vehicle drives into the frame and comes to a complete stop in the middle lane of 71. The car seemed to have missed the output to 670 and turns on the right indicators and waits for the possibility to cut traffic over the output of 670.

Brought to you

Two cars then stop behind the vehicle before a third leads the cars to a multiple-car pop-pop-pop. The original red vehicle makes it safe to exit 670.

“If you drive a large motorway and miss your exit, do:

A) drive on and get off the next one

or

B) Come to a complete stop, cause a multi-car rear waste and then drive away

Note: The answer is never B. is not this driver. Actions such as those in the video are extremely dangerous for themselves and other drivers, ”says the Odot Post.

You can watch the video below.

Would you like to read more? Take a look at our print publications (614) Magazine and Stock & Barrel. Find out where you can find free copies of our latest problems Here!

Leave a Comment